Condition checks

Check one piece of equipment, any time.

Something on the port generator doesn't look right. A battery bank seems slow to recover. You don't need to walk the whole boat: take a few photos of that one component and get back its condition and what's changed.

Harbor Guardian · Condition checks
Port generator
The coolant trail below a hose joint has grown since July.
Changed
Hour meter
Reads 2,184 hours, saved to the component.
Confirm
Raw water pump
Seen on the engine but not recorded yet.
Suggested
01 What you get back

Condition, change, and the details on the label.

Current condition

Anything worth attention, called out with the photos behind it.

What has changed

Compared with earlier photos of the same equipment.

Serial numbers and hour meters

Read from labels and gauges, saved on the component for you to confirm.

Unrecorded sub-parts

A raw water pump on an engine, a filter housing on a watermaker, suggested as new components.

Close-up of a marine generator hour meter and brass data plate
Straight from the gauge

Numbers from the meter, not from memory.

Hour readings and serial numbers are read straight from your photos of the gauge and the data plate, then saved on the component. The next service interval starts from a real number.

02 Why it matters

Catch the drift, not just the failure.

Most equipment problems start small: a weep at a seal, a little discoloration at a mount, a reading that creeps up. Seen once, they're easy to dismiss. Seen against photos from three months ago, they tell a story.

Anything that needs action goes into the same review queue as a full inspection.

March

Dry, clean mount and hose joints on the port generator.

Baseline
June

A faint coolant trail appears below one hose joint.

Changed
August

The trail has grown and the joint is damp.

Needs review
September

Clamp replaced; the joint is dry on the follow-up check.

Verified
Questions

Condition checks, answered.

Q What is an equipment condition check?

A quick photo check of one piece of equipment, such as a generator, pump or battery bank, between full inspections. Take a few photos and Harbor Guardian reports its condition, what changed since the last check, and the details it can read from labels and gauges.

Q Can Harbor Guardian read hour meters and serial numbers from photos?

Yes. When a photo shows a data plate, label or hour meter, Harbor Guardian reads the make, model, serial number and hours and suggests adding them to the component's record. You confirm each value before it's saved.

Q How often should a yacht's generator be checked?

Look it over weekly while the boat is in use: oil and coolant levels, belts, water flow at the exhaust, and any leaks, soot or salt crust. Log the hours each time, because generator service intervals run on hours. The generator's manual sets the service intervals themselves.

Q What's the difference between a condition check and an inspection?

An inspection covers the whole boat, space by space. A condition check covers one component in detail, so you can watch equipment you're concerned about, or record its readings, without walking the whole boat.

See it on your boat

Walk through Harbor Guardian with us.

Book a demo and we'll show you the whole loop on a real yacht: an inspection, the findings it raised, and the work that closed them out. Bring your questions about your own boat or the fleet you manage.